Products

Where would you use a hand swager ? When doing wire cable balustrade for System 3, where you are using hand swaged fittings (those that are used in...

Where would you use a hex hand swager ? When doing wire cable balustrade for System 11 and System 12 you need to be able to crimp the ends of the h...

Where would you use a hydraulic MINI wire swager ? When doing wire cable balustrade using hydraulically swaged fittings, this tool will allow you t...

Where would you use a hydraulic PRO wire swager ? When doing wire cable balustrade using hydraulically swaged fittings, this tool will allow you t...

When ordering the Rivet Nut Inserter (IF124X), you are only supplied with a M6 Right-Hand Thread mandrel, not a M6 Left-Hand version. If you nee...

Peek polish is used to clean, polish and protect stainless steel. Ideal for wire balustrades and handrails; simply apply the polish with a wet clot...

When ordering the Rivet Nut Inserter (IF124X), you are already supplied with one of these M6 Right-Hand Thread mandrels, so you DON'T need to order...

Where would you use a rivet nut tool ? When doing wire cable balustrade or glass balustrade and you need to be able fix the glass clamps or wire fi...

Glass standoffs can be tightened by hand, but a far quicker and better method is to use one of these spanners. It suits both 38mm and 50mm diam...

The wire balustrade tension gauge is the quickest way of making sure that your wire balustrade cable is tensioned enough to comply with current Aus...

Where would you normally use it ? To assist in the correct alignment of drilling holes for Zipbolt installation. How do you use it ? It is a littl...

Where would you normally use it ? To assist in tightening or loosening a zipbolt. It's small compact design help to get into tight spots.