Skip to content
About Us Our History Custom Woodturning Blogs & News The Workshed FAQ Downloads Review Us Contact Us
Square Intermediate Post with 2x11 Holes (Open Top) - Satin

Square Intermediate Post with 2x11 Holes (Open Top) - Satin

SKU: SSP103-S6

Material: Satin 316 Stainless

$173.80 - $173.80
$173.80
$173.80 - $173.80
$173.80

  per Piece

  • In Stock
  • Ships from Brisbane

Quantity (per Piece):

Please Read Before Ordering

These posts are specially made when an order is placed. Unless the post is defective in some way, NO REFUNDS will be given if you have ordered the wrong post or you decide to change your mind and want to return it.

Description

Where would you normally use a square intermediate post with 11 Holes on either side?
As an intermediate post to structurally support a horizontal wire cable balustrade on a deck or balcony.
On a wire balustrade, you need to have a support post approximately every 1.5 metres (when using 3.2mm wire cable).

Which fixings go with this post?
Any of the square rail supports in a sating finish.

What is it made out of?
316 Stainless Steel in a Brushed Satin Finish.

What are the important dimensions?
Overall Height: 960mm, once one rail supports have been added.
Wall Thickness: 1.6mm.
Width: 50.8mm
Depth: 50.8mm
There are 2 rows of 11 holes (each of 4mm diameter) drilled on opposite sides of the post. They are spaced 80mm apart so as to conform to regulations for wire cable balustrade.

How should you fasten it to the ground/deck?
Due to the large number of surfaces that the post could be fixed to, we do not supply any fasteners.
We suggest that you speak to a local hardware store for more info.

*** IMPORTANT - PLEASE READ ***

These posts are specially made when an order is placed. Unless the post is defective in some way, NO REFUNDS will be given if you have ordered the wrong post or you decide to change your mind and want to return it.

Cleaning & Maintenance

Without regular cleaning and maintenance discolouration of the surface of the stainless steel by corrosion (tea staining) can occur.

How to reduce the risk of tea staining

  • Absence of corrosives – especially salt, chlorine, cleaning acids etc.
  • Atmospheric Conditions – lower temperatures and low humidity are better.
  • Surface orientation – Open exposure to rain washing is better
  • Surface Finish – In general a smoother finish is better. where practical mirror polish finish may perform better than a brushed finish.
  • Chemical cleanliness or passivation of the surface improves corrosion resistance
  • Appropriate grade selection for conditions
  • Regular Maintenance to limit the accumulation of corrosives

Stainless steel cleaning schedule

The frequency of cleaning will vary depending on environmental factors i.e. proximity to the ocean, atmospheric and urban conditions. Below is intended as a guide and should be varied as required. We recommend using peek stainless steel polish for maintenance.

Environment Distance from Coastline Cleaning Schedule
Clean inland environment 20km + Every 10 - 12 Months
Moderate urban or coastal environment 1-5km Every 4 - 6 Months
Harsh urban or coastal environment < 500m Every 2 - 3 Months
Severe coastal/ marine environment < 500m Every 1 - 2 Weeks